DMT Presenter Control Guide de l'utilisateur télécharger pdf (Page 15)

S1 User Handbook

INTRODUCTION

Installation Notes

Atmosphere

The S1 mixer should be installed in an area which is not subject to excessive heat or cold.

Also, you should avoid installing it in atmospheric conditions which are dusty, smoky, or

dirty, or where there is moisture or vibration. Do not use any liquids to clean the fascia of

the mixer: a soft dry brush is ideal. Use a clean cloth moistened with water or ethyl alcohol

to clean the trim and scribble pads. Other solvents may cause damage to paint or plastic

parts.

Electromagnetic Radiation

Avoid using the S1 mixer close to strong sources of electromagnetic radiation such as, video

monitors or high power electric cabling. This may cause degradation of the audio quality

due to induced voltages in connecting leads and chassis. In all cases the S1 mixer should be

installed and serviced by qualied personnel.

Dimensions and Cut-Out Sizes

The cut-out size is for reference only and should be checked with your mixer.

S1 cut out

viewed

from above

Table top front edge

440mm

-0

381mm

-0

Fig 1-2: Dimensions & Cut-Out Sizes For S1 Mixer

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

Pas de commentaire

DMT Presenter Control Guide de l'utilisateur Page 15